Basic Introduction Of The Stop Collar
A double-circle offset type outer ring replaces the pillow block. It is used to secure nozzle parts for ease of assembly. The width of the Stop collar is designed to be zero interference and its outer diameter is smaller than the diameter of the root of the thread. In the pressure gauge, the wave Stop collar is mounted in a shallow groove, which produces only very little pressure on the surface glass. This way the Stop collar can both fix the surface glass without crushing the glass.
The Stop collar forms a side wall on both sides of the timing pulley. This method eliminates the press-in side walls. In order to facilitate the replacement of the belt, the Stop collar on one side is easy to disassemble. Wave Stop collars are easy to meet on-site repair requirements. If the cylinder seal needs repair, the collar can be quickly removed with a screwdriver and easily reinstalled. The use of circlips eliminates the need for a pillow block design, reduces shaft size, and saves material and machining time. In addition, wave springs are also widely used, such as adjustable pulleys, bearing preloads, electrical connections, hydraulic seals, clutches, ball valves, fluid valve couplings, etc.
The circlip for the shaft is mounted on the slot shaft and used as a hole for moving the fixed component. The inner diameter of the Stop collar is slightly smaller than the diameter of the mounting shaft. The hole Stop collar is installed in the hole of the machine and equipment, and plays the role of preventing the left and right parts of the hole from moving.
1. The two are first of all different tools. The two are used for the shaft Stop collar pliers and the hole Stop collar pliers. The main difference is that the shaft Stop collar pliers is a special tool for disassembling the shaft spring Stop collar. When the hand of the circlip pliers is grasped, the jaws are opened; the circlip pliers for the holes are used for the spring Stop collar of the disassembly holes, and the jaws are closed when the hand is grasped tightly.
2. The position and size of the two small holes of the circlip pliers are different.
3. The shape is different and the force is different. The two small holes for the shaft are outside the Stop collar and are to be extended outwardly into the workpiece. The holes are reversed. The shaft is pressed on the shaft, which is commonly used to block the bearing. The hole is fixed in the inner hole to block the outer ring of the bearing to prevent turbulence.
